Recently Updated Pages
Which audio device should I use?
The appropriate audio device depends on your setup. Take the following rules of thumb into accoun...
Configure the Basler USB 3 camera
Aim To adjust settings in the USB 3 camera, like the video frame rate, resolution, and exposure....
Connect the USB 3 cameras to the PC
Connect the cameras to the USB 3 interface card of the MediaRecorder computer. TIP USB 3 conn...
Install the USB 3 camera driver
Aim To install the software that allows communication between your camera and the operating syst...
The steps to install USB 3 cameras
Prerequisite You have USB 3 cameras that supported with MediaRecorder. See Supported USB camera...
Configure the cameras
Aim To adjust settings in a Basler GigE camera or USB 3.0 camera, like the video frame rate, vid...
Set camera IP address
Aim To make sure that the IP address of the GigE camera and that Ethernet interface board physic...
Install MediaRecorder with the camera drivers
Aim To install the software that allows communication between your camera and the operating syst...
Connect the GigE cameras to the PC
Prerequisite You have followed the entire procedure in Ethernet card setup in Set up IP camera...
Select ONVIF cameras in MediaRecorder
Aim To select a camera that supports ONVIF Profile S in MediaRecorder. If your device does not ...
Create camera settings
Aim To configure the camera for optimal recording with MediaRecorder. Prerequisites You have...
Set camera password and select power line frequency
Aim To give the camera a password, which is compulsory, and to select the power line frequency o...
IP cameras
When do I need an IP camera? IP cameras are connected directly to a network. IP cameras are espe...
Connect IP cameras to the PC
Prerequisite You have followed the entire procedure in Ethernet card setup Procedure The proce...
Set Ethernet card IP address
Aim To set the IP address of the Ethernet card to the same range as the cameras and the computer...
Install the Ethernet card
Aim To place the Ethernet card into the computer with MediaRecorder. Prerequisites You hav...
Ethernet card setup
Aim To insert the 1 Gb Ethernet card into your computer and to configure it to work with MediaRe...
Change video standard
Aim To specify the correct video standard to be used by the Picolo Alert PCIe card. Procedure...
Connect the analog camera to the computer
important By default Windows 10 computers have the option Fast startup enabled. This means that ...
Install the Picolo Alert PCIe card
Aim To install the card that digitizes the output of analog cameras. Prerequisites You use M...