Set camera IP address

Aim

To give the camera a fixed IP address that is in the range of the Ethernet card. This ensures that MediaRecorder can access the camera video stream.

Prerequisites

• You followed the procedure in in Ethernet card setup
• You connected the camera. This is the same procedure as connecting an IP camera.
  See Connect IP cameras to the PC in  in Set up IP cameras

Procedure

1. 1.Double-click the the Pylon IP Configuration tool  icon on the desktop.

   

2. Select the camera under under Local Area Connection.

   

3. Fill in the the IP Address  and and Subnet  Mask  fields under under Static IP Address  as supplied by your system administrator.

   

4. Click Click Save  and then then Close.
5. If you have multiple cameras, connect the next one and repeat the steps above.

Note

Your cameras should have the same Firmware version. Check this in the Pylon Viewer software. In the the Features Features panel, under under Device  Information, check check Firmware Version. If the cameras do not have the same firmware, an upgrade/downgrade must be done.