The steps to install USB 3 cameras

Prerequisite 

 You have USB 3 cameras that supported with MediaRecorder. 

 See  Supported USB cameras  in  Recording devices 

 Which situation applies to you? 

 

 You ordered the computer, cameras and MediaRecorder from Noldus IT. 

 

 In case of Basler USB 3.0 cameras, your computer has a USB 3 card and its drivers are installed. The cameras are configured. Also MediaRecorder has been set up to use with these cameras. You can connect your cameras and start recording. 

 See  Connect the USB 3 cameras to the PC  and  Record video 

 

 You bought the computer somewhere else. 

 

 Carry out the entire  Procedure  below. 

 Procedure 

 

 In case of Basler USB 3 cameras, install the supported USB 3 interface card, even if your computer already has USB 3 ports. See  Install the USB 3 interface card 

 Carry out the prerequisite steps before installing MediaRecorder. See  The steps to install MediaRecorder  in  Installation 

 Install (MediaRecorder with) the camera driver. Installing the camera driver is only needed for the Basler USB 3 camera. For the Logitech BRIO no driver installation is needed. See  Install the USB 3 camera driver 

 Connect the USB 3 cameras to the PC 

 Configure the Basler USB 3 camera 

 

 See also 

 Supported USB cameras  in  Recording devices