The steps to install GigE cameras

Prerequisites

Which situation applies to you?

Procedure

  1. Install the Ethernet card. This is the same procedure as for IP cameras.

See Install the Ethernet card in Set up IP cameras.

To record from multiple cameras you can use a 4-port PCIe board. MediaRecorder has been tested with the Adlink PCIe-GIE74 Ethernet board.

image.png

  1. Give the Ethernet card a fixed IP address. This is the same procedure as for IP cameras.
    See Set Ethernet card IP address in Set up IP cameras
  2. Connect the camera to the computer with MediaRecorder.
    See Connect the GigE cameras to the PC 
  3. Carry out the prerequisite steps before installing MediaRecorder.
    See The steps to install MediaRecorder in Installation
  4. Install MediaRecorder with the camera drivers
  5. Set camera IP address
  6. Configure the cameras

I bought the cameras from Noldus IT and istalled MediaRecorder on my computer

You must carry out the following steps:

  1. Install the Ethernet card. This is the same procedure as for IP cameras.

See Install the Ethernet card in Set up IP cameras

  1. Give the Ethernet card a fixed IP address. This is the same procedure as for IP cameras.
    See Set Ethernet card IP address in Set up IP cameras
  2. Connect the camera to the computer with MediaRecorder.
    See Connect the GigE cameras to the PC
  3. Carry out the prerequisite steps before installing MediaRecorder.
    See The steps to install MediaRecorder in Installation
  4. Install MediaRecorder with the camera drivers

Revision #9
Created 1 December 2023 10:19:20
Updated 20 December 2023 13:47:08