Create camera settings

Aim 

 To configure the camera for optimal recording with MediaRecorder. 

 Prerequisites 

 

 You have Axis IP cameras that are supported with MediaRecorder. See Supported IP cameras  in  Recording devices 

 

 

 You installed the Ethernet card. See Install the Ethernet card 

 

 

 You gave the card a fixed IP address. See Set Ethernet card IP address 

 

 

 You connected all cameras. 

 You gave the cameras an IP address. See Set camera IP address 

 

 

 You gave the camera a password and selected the correct power line frequency. See  Set camera password and select power line frequency 

 

 Procedure 

 Carry out the following steps: 

 

 Access camera settings 

 Create ONVIF User name and Password 

 Disable replay attack protection 

 Switch on IR cut filter 

 

 Note 

 The procedure below describes the camera firmware version 7.20.1. For other firmware versions, search for comparable settings. 

 Access camera settings 

 

 Open the camera in a browser by clicking the Home page button in the IPUtility tool or typing the IP address in the address field of an Internet browser. Then enter the password. 

 Click the Settings button in the bottom-right corner of your window. 

 

 

 

 Create ONVIF User name and Password 

 Aim 

 To configure the camera so that pan, tilt, zoom, and audio recording is possible. 

 Procedure 

 

 Open the camera settings.

 

 See  Access camera settings 

 

 

 Open the System tab and click ONVIF .

 

 

 Click Add and enter the same User name and Password as set in Set camera password and select power line frequency . Do not use the characters @, space, or colon (:) for the user name or password. These characters cannot be used in MediaRecorder. 

 Select Administrator as User Group and click OK .

 

 

 

 Notes 

 

 If the camera does not support ONVIF, pan, tilt, and zoom must be done with a browser and audio of the camera cannot be recorded. All IP cameras supported with MediaRecorder support ONVIF. 

 IMPORTANT   Always close the browser before you start recording with MediaRecorder. 

 

 Disable replay attack protection 

 Aim 

 To prevent that connection to the camera fails if the time of the MediaRecorder computer differs from the time in the camera. 

 Background 

 Replay attack protection is a camera security setting. Relevant for video recording with MediaRecorder is that replay attack protection causes the camera connection to fail if the timestamps of MediaRecorder and the camera are not exactly the same. Replay attack protection is necessary for security cameras, but not for IP cameras in a dedicated network. 

 Procedure 

 

 Open the camera settings. See  Access camera settings 

 Open the System tab and click Plain config . 

 From the list at the bottom, select WebService and click Select Group . 

 Under WebService UsernameToken :, make sure the checkbox Enable replay attack protection is not selected. 

 

 

 

 Note 

 If you do not want to disable this option, make sure that the clock times of the computer and camera are exactly the same. 

 Switch on IR cut filter 

 Aim 

 To make sure the cameras does not switch to black and white at low light levels. 

 Background 

 The IR cut filter removes infrared light during daylight. With the default camera settings, the IR cut filter is switched off at low light intensities. The camera then records in near-infrared, which gives a black and white camera image. If you do not want this, set the IR cut filter to On instead of Auto, so that it stays on, independent of the light level. 

 Procedure 

 

 Open the camera settings.

 

 See  Access camera settings 

 

 

 Open the  Image   tab. 

 Check if there is an option IR cut filter . If so, set it to On . 

 

 

 Note 

 Not all IP cameras supported with MediaRecorder have an IR cut filter.