Connect the GigE cameras to the PC

Prerequisite

do not use USB to connect camera.png

Procedure

  1. Using cross-network cables (cat-5e or newer), connect the Ethernet card on the PC to the IN port of the PoE-injector. Connect the camera to the OUT port. Use the short cable between PoE-injector and PC. Use the long cable between PoE-injector and camera.
  2. Power up the PoE-injector; make sure that the two CONNECT and ON green LEDs are on.

If the green LEDs keep blinking, wait a few more seconds. If you see no change, disconnect the cables, then re-connect them.

image.png

Notes

image.png


Revision #9
Created 1 December 2023 09:30:36
Updated 2 January 2024 20:28:54